Customer ratings for Showlite LED Tube Light T8W24K45F-1200 1200mm Set of 2 (daylight white 4500 K)

Super lamps. Go on immediately, save electricity.
Thank you!

Am very satisfied .
Super packed.
Delivery super fast.

After I have already tried some time ago these LED tubes I am so repeat offender ;-)
Simply change enclosed starter and insert tube. Done, Very good and pleasant light and immediately (unlike slowly approaching fluorescent tubes). Not to mention the much lower power consumption of such LED tubes. But also compared to other LED tubes, I will from experience "Showlite" LED tubes in the future prefer others.

1a goods very fast delivery gladly again thank you

everything ok. Bright light and unlike fluorescent lamps no more choke hum. Am very satisfied.

I am very satisfied and can only recommend this item. The change of the tubes was very simple. I could do the exchange myself without any problems. The price-performance ratio and the delivery were perfect. Too bad that I have already exchanged everything, because then I would buy everything through Kirsten. Thank you and kind regards Reinhard.

Goods as described and delivered quickly. Fits in any conventional neon lamp with 60cm tube length incl. starter ! And the most beautiful - you save electricity!

LED tubes are the really sensible replacement for the old fluorescent tubes. The exchange is easy because each LED tube is also the appropriate starter enclosed.

Easy conversion from fluorescent to LED without changing anything in the installation. Super

LED bulb could not install in damp proof fluorescent lamp without problme. The screw connections did not fit.

This replacement article for conventional neon tubes is characterized by a great light output and makes any old neon tube look very old.

The installation is quite simple and safe (even for laymen) to manage.

Thanks to the included replacement starter, which is electrically only a jumper wire, no conversion inside the neon tube fitting is necessary.

However, I myself have completely removed the ballasts, the starter sockets and the suppressor capacitors from my double tube socket, as these are technically absolutely unnecessary and only represent further - albeit minor - power consumers.

The supplied operating / installation instructions are clear and concise.

If you wire the sockets as suggested, the direction in which the LED tubes are inserted doesn't matter at all, as there is also a jumper wire at the second end of the tubes that closes the circuit.

However, due to the removal of the old "innards" (ballasts, etc.) one or the other connection cable may be too short and must then be additionally extended.

However, it is sufficient to connect only one side of the neon tube socket (one pole to the neutral [N], one pole to the phase [L]) if you want to keep the wiring simple and don't want to make a big effort during the conversion.

This is the simplest variant, but the end of the LED tube on which the letters N and L are applied to the pin base must be used. This fact should not be forgotten if you want to change the LED tube after many years. If you insert it the wrong way round, it will remain dark.

Of course, this advanced conversion may only be carried out by a trained electrician.

Incidentally, the bulbs were safely packaged and shipped super fast.

Kirstein has here a very great environmentally friendly product in sales.

I am very satisfied with it.


Christian Neunteufel
from A-6850 Dornbirn